![]() STD - The backup cycle appends reports to an existing DR backup tape during Interim backup cycles and creates a new DR backup during Standard backup cycles. ALWAYS - The backup cycle always appends reports to an existing DR backup tape until it becomes full. NEVER - The backup cycle does not append reports to an existing DR backup tape. * A new DR backup tape can be created for both the Standard and Interim backup cycles depending on how the DRMOD parameter is set, as follows: The DR tape is written during the current Standard or Interim backup cycle and can be sent to the DR site. * This tape is not a mirror image of the primary or duplex tape. View can also create a DR tape if the DRTAPE parameter is set to YES or ACTIVE. A sub parameter of the STORGRPn parameters (unit2-name) determines whether tape duplexing is done. View allows you to produce a duplicate of its backup tapes. The TBACKUP initialization parameter determines whether backup and DR processing are done. See the information about backing up and recovering the database in Reference Guide.Īs part of its backup cycle, View optionally backs up to tape the current disk archive generation of SYSOUT, along with the master index. ![]() You can configure your View initialization parameters to create up to three different types of backup tapes: Primary, Duplex, and DR (Disaster Recovery) tapes.ĭuplex tapes - mirror images of the Primary tapesĭR (Disaster Recovery) - can be taken offsite for disaster recovery purposes ![]() Please refer to the following areas of documentation for additional information. Regarding your View case and question on duplication of SARTAPE to be used at a backup site, View does in deed provide a couple of options.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |